Victron Phoenix Smart IP43 Charger 24/25(3) 230V Charger

Bluetooth Smart enabled Any Bluetooth enabled smartphone, tablet or other devices can be used to monitor, to change settings
and to update the charger when new software features become available.
Phoenix Smart (1+1): two outputs to charge 2 battery banks The second output, limited to approximately 3A and with a slightly lower output voltage, is intended
to top up a starter battery.
Phoenix Smart (3): three full current outputs to charge 3 battery banks Each output can supply the full rated output current. But the total of the 3 outputs combined can never
exceed the current rating of the charger.
Automatic voltage compensation The charger compensates for voltage drop over the DC cabling by slightly increasing output voltage
when the DC current increases. Please see the manual for details.
Adaptive 5-stage charge algorithm: bulk – absorption – recondition – float – storage The Phoenix Smart Charger features our well-known ‘adaptive’ battery management system that can
be preset to suit different types of batteries. The ‘adaptive’ feature will automatically optimize the
charging process relative to the way the battery is being used.
The right amount of charge: variable absorption time When only shallow discharges occur (a yacht connected to shore power for example) the absorption
time is kept short in order to prevent overcharging of the battery. After a deep discharge, the
absorption time is automatically increased to make sure that the battery will be fully charged.
Preventing damage due to excessive gassing: the BatterySafe mode If, in order to quickly charge a battery, a high charge current in combination with a high absorption
voltage has been chosen, the charger will prevent damage due to excessive gassing by automatically
limiting the rate of voltage increase once the gassing voltage has been reached (see the charge curve
between 14,4 V and 15,0 V in fig. 2).
Less maintenance and aging when the battery is not in use: the Storage Mode The Storage Mode kicks in whenever the battery has not been subjected to discharge for 24 hours.
In the Storage Mode, float voltage is reduced to 2,2 V/cell (13,2 V for a 12 V battery) to minimize gassing
and corrosion of the positive plates. Once a week the voltage is raised back to the absorption level to
‘equalize’ the battery. This feature prevents stratification of the electrolyte and sulphation, a major
cause of early battery failure.
Also charges Li-ion (LiFePO₄) batteries Charger on-off control can be implemented by connecting a relay or open collector optocoupler
the output from a Li-ion BMS to the remote on-off port.
Alternatively, full control of voltage and current can be achieved with Bluetooth.
Fully programmable charge algorithm The charge algorithm can be programmed with the help of Bluetooth or the VE. Direct interface.
Three preprogrammed algorithms can be selected with the mode button (see specifications).
Remote on-off The remote on/off consists of two terminals: Remote H and Remote L.
A remote on/off switch or relay contact can be connected between H and L.
Alternatively, terminal H can be pulled high, or terminal L can be pulled low.
See the manual for details.
VE.Direct interface For a wired data connection to a Color Control panel, PC, or other devices.
Please see the VictronConnect app under Downloads / Software on our website.
Programmable relay It can be programmed using the VE. Direct interface or a Bluetooth enabled device
to trip on an alarm or other events.
Learn more about batteries and battery charging For more information about adaptive charging please look under Downloads / White papers on our
website.
AC-connection IEC 320 C14 inlet with retainer clip (AC cord with country-specific plug must be ordered separately) Please note: There is no additional cables included with this product.